View Full Version : Power Failure
Haaspack
02-02-2007, 04:44 PM
I was 1/3 of the way through a project and the mach. just shut off..
i have checked the power supply and that is working
checked the contrast
cleaned the mach with air and suction
there is still no power
is there a circut breaker on the mach? or motor?
GIZMO1D1
02-02-2007, 04:57 PM
http://www.carvewright.com/forum/viewtopic.php?t=1325
thats what happened to me..
the link above will show ya what i had to do//
FdxGuy
02-04-2007, 09:18 PM
Great troubleshooting job.
I noticed a computer powersupply in one of the pictures. Did you try to power up the unit with that? Did it work?
I may have a bad powersupply too. Wondering if that would be an easy step.
Thanks,
Bill
The Bard
02-04-2007, 10:45 PM
if you call us up and let us check a few things we can send one out if you need it.
we've redesigned them to uninstall and install MUCH easier now.
GIZMO1D1
02-05-2007, 06:47 AM
YES...only to check display board.. that kinda helped narrow it down..
5/24 volts /dc .. same conection on 4 pin plug /
simple now / check out board were power supply comes in / remove 4 pin plug / using meter check / 2 bottom pins=5vdc top 12/24vdc/
BobHill
02-05-2007, 09:01 AM
I'm curious .... did you also hear a 60hz hum when no motor was running nor trying to run? All of a sudden, my machine is giving off a very low volume hum periodically and I havn't yet isolated where or why or what is causing it, however, when it's there, I seem to get sensor problems (but that could be coincidence).
Bob
The Bard
02-05-2007, 10:57 AM
Gremlins
BobHill
02-05-2007, 11:08 AM
But those Gremlins should be happy, Bard. I've fed them enough green beer, at least, they should be by now ! :wink:
Bob
HandTurnedMaple
02-05-2007, 11:10 AM
But those Gremlins should be happy, Bard. I've fed them enough green beer, at least, they should be by now ! :wink:
Bob
Could it therefore have something to do with you dumping green beer on your CW???? :shock:
BobHill
02-05-2007, 11:20 AM
Dump beer? Not on your life. Anything the Gremlins don't get, I make sure never goes anywhere but internally within ME. It's Guinness, after all.
Bob
FdxGuy
02-05-2007, 01:27 PM
Dump beer? Not on your life. Anything the Gremlins don't get, I make sure never goes anywhere but internally within ME. It's Guinness, after all.
Bob
I am fairly certain that Guinness is a suitable substitute for any other Flexshaft lubrication!!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.