PDA

View Full Version : Is this possible?



dehrlich
12-20-2012, 06:30 PM
Anyone think it's possible to make a carvable pattern from the attached photo? I have tried editing it seveal ways and it just doesn't look very good, too much extra noise. No hurry, just one of my fav photos of my boy. Any suggestions are appreciated.

57945

mercer57
12-20-2012, 07:04 PM
would make a nice litho

mercer57
12-20-2012, 07:24 PM
OK I gave it a try let me know if this works.

gregsolano
12-20-2012, 09:54 PM
Here is my go at it

57953

Alan Malmstrom
12-20-2012, 10:12 PM
Thats a nice dog. I have touched up the photo a little to make a better carve.

5795557956

radman5506
12-22-2012, 10:45 AM
Nice job Alan looks like what dehrlich might be looking for. I have a project that I put together but when I carved it a lot of the detail carved really thin, like almost paper thin. I tried making adjustments and was able to get it a little better but had difficulty. The original was done in metric and I just don't handle metric well. Is there anyone that can tell me how to convert it to standard measurement. Thank You in advance.