PDA

View Full Version : install bushes on cut motor



aokweld101
12-20-2012, 06:15 PM
having problems, I insalled bushes on the cut motor and replaced the board censor I have replaced the bushes before and had no problems..I went though the censor check and all was Ok all but when I checked the cut motor it said it was running but it was'nt, any suggestions on how to attack this thing would be appreciated......

aokweld101
12-20-2012, 06:21 PM
excuse me forgot the r in "brushes"

chief2007
12-20-2012, 06:23 PM
Check the cut motor switch, the cover may not be making good contact with the switch.

I had that happen today after changing the brushes on my cut motor along with the rest of the 250 hours maintenance checks. Had to adjust the switch positioning

If it not the switch you could have a bad connection or wire in the motor.

Did you blow the dust out before installing the new brushes?

Also make sure the wire connection are secure and tight

aokweld101
12-20-2012, 07:00 PM
hiya chief, that was my first thought too, it is missing a screw to the cover censor on the right side, but when i put the cover swicth down i can hear it im going look again in the morning....thank you