Does anyone have these patterns already? Army and airborne

[dehrlich]

Wondering if anyone has clean patterns for the one's I'm trying to use already on this sign. Trying to make for my son for Christmas. Obviously I tried to do them from jpegs, not working so good. Any help would be appreciated. Searched the forum and didn't find them. Thanks!

57753

[badbert]

This is a good place to start! http://forum.carvewright.com/showthread.php?17358-Insignias-amp-Military

[gsdsj]

This help, Greg

[dehrlich]

Awesome, thank you Greg!

[gsdsj]

post a pic of your finished project!

[dehrlich]

Well I don't know how it will carve, but here is what I came up with.. Any suggestions?

57764

[badbert]

Don't forget to use bit optimization!

[dehrlich]

Pretty sure I set everything to best, but I always double check before I upload.

[fwharris]

How I would do it..

I set all of the depths the same as your carve region, added medium draft, changed some of the heights and applied bit opt. best to all...

notice you might get a small amount of chipping on the edges of the airborne logo.. zoom in and see the fine outer edge..

[gsdsj]

Looks like you might chipout problems around the edge of the top tab. I cleaned the edges up on this one, give it a try.

[dehrlich]

Looks like you might chipout problems around the edge of the top tab. I cleaned the edges up on this one, give it a try.

Thanks I will try that!