View Full Version : Adjust depth
ONLY WINGE
12-09-2012, 02:49 AM
:confused: Can anyone please help me? I carve my words useing the 90 degree V bit and I make sure my board is leval and flat. But A lot of the time I can not even read as it will not cut deep enough , is there a way to get my wrods to cut deeper? Do I need to use a differant bit , or am I doing something wrong again. Thank You Jim
bjbethke
12-09-2012, 08:08 AM
:confused: Can anyone please help me? I carve my words useing the 90 degree V bit and I make sure my board is leval and flat. But A lot of the time I can not even read as it will not cut deep enough , is there a way to get my wrods to cut deeper? Do I need to use a differant bit , or am I doing something wrong again. Thank You Jim
If you are using Centerline fonts you need to pick a bolder font. If you use the 60 degree Vbit it will carve deeper.
I some times use my FontCreator program and use the Erode function to make the font letter or drawing bolder, that also works.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.