View Full Version : cut path cd holder
aokweld101
12-01-2012, 06:51 PM
I downloaded the cd holder off the forum my question is;on the carve out it did the cut path in one pass which is .75 thick.. on the cut out I read that it was only suposed to do a .5 at the max for one pass am I correct or can I change the dept for the cut path or leave it alone.
eelamb
12-01-2012, 07:05 PM
You can change the depth of the cut path and is recommended.
jaroot
12-02-2012, 11:15 PM
In the past I've had no problem doing full depth cuts in soft pine/poplar with the 1/8" cutter. Now I try to use the 3/16" bit for cut throughs and have no prob with single pass cuts. For hard woods I still do multiple passes.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.