View Full Version : Board Tracking Encoder Damper
Gary Koval
11-29-2012, 10:59 AM
Does anyone know the exact position of part 99 the "Board Tracking Encoder Damper"? While cleaning I removed the squaring plate strongback and did not realize that the damper fell out until later, now while assembling I'm at a standstill. Not sure if it covers a screw upright or sits underneath some place horizontally. Any help is appreciated...
Gary
lynnfrwd
11-29-2012, 11:18 AM
Have you looked at installation instructions? Those might help...http://www.carvewright.com/assets/service/Service_instructions/CarveWright_service_replace_board_tracking_sensor. pdf
Gary Koval
11-29-2012, 01:31 PM
Lynnfrwd,
I know, "if brains were dynamite..." anyway, thanks for the info, I was looking at the exploded parts page, didn't think about the installation instructions.
Thanks,
Gary
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.