View Full Version : AskBud Dust Collector Fitting
Northwoods Woodcrafter
11-28-2012, 03:15 PM
Hi.. i just downloaded, carved and assembled the dust collector for my machine. It looks like it will do a good job once I can find a source for the 4" 45 degree fitting. I've spent a bit of time searching but so far no luck.
Anyone know where I can find one?
Thanks!
Pete
chief2007
11-28-2012, 03:20 PM
Don't know if this will work but here is something I found on amazon http://www.amazon.com/gp/aw/d/B0035Y7OYS/ref=redir_mdp_mobile/183-9634104-1910014
Northwoods Woodcrafter
11-28-2012, 03:33 PM
Thanks for the response, chief. I saw several elbows but not one that has a plate and holes for mounting. Most are 2 1/2" for router fence mounting.
pete
AskBud
11-28-2012, 03:46 PM
Hi.. i just downloaded, carved and assembled the dust collector for my machine. It looks like it will do a good job once I can find a source for the 4" 45 degree fitting. I've spent a bit of time searching but so far no luck.
Anyone know where I can find one?
Thanks!
Petewhen I designed this my top loaded Vacuum Head, which may be what you now have, I got my 4" 45 degree fitting at the Wood Craft Store.
AskBud
Northwoods Woodcrafter
11-28-2012, 04:39 PM
Thanks! Yes... I do now have your system. I checked Woodcraft but didn't find one. I'll check again.
Pete
Northwoods Woodcrafter
11-28-2012, 05:28 PM
Woodcraft only has a 2 1/2" fitting in that config. I may have to adapt the collector for a straight fitting. Shouldn't be too much problem. I may just take the top off the machine altogether. No kids in my household.
pete
AskBud
11-28-2012, 05:46 PM
Woodcraft only has a 2 1/2" fitting in that config. I may have to adapt the collector for a straight fitting. Shouldn't be too much problem. I may just take the top off the machine altogether. No kids in my household.
pete
Here it a link to the item.
It may not be a true 46 degree, but you can see it's on an angle.
AskBud
http://www.woodcraft.com/product/2000899/7414/4-universal-fitting.aspx
Northwoods Woodcrafter
11-28-2012, 07:49 PM
Thanks! I don't know how I missed it.
Pete
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.