View Full Version : Error 321
jspringertx
02-01-2007, 09:34 AM
I received error 321 (homing error) and cannot seem to clear it. Has anyone had this error before and how did they solve it?
I have contacted tech support, but no answer as yet.
I have the same problem. Mine started after the carving bit went all the way through the 3/4" board I was carving. I've read other posts with a 246 error and am going to go check out a couple of cables before I holler 'HELP!' Carved my first project on Friday with no problems. I'm hoping my problem is a loose cable. Good luck.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.