View Full Version : Cutting out a pattern
bil381
10-30-2012, 06:45 PM
I am tring to cut out a pattern that my wife traced on a paper and scaned. I don't want it carved but I want the lines cut out. Is there any way to do it?
dbfletcher
10-30-2012, 07:11 PM
Here is a quick trace and dxf import. I assigned the 1/8 cutting bit. I wouldnt run this project as is because there are no tabs to hold the inner pieces in. But it should give you a start.
bil381
10-30-2012, 09:14 PM
Thanks a bunch. It supposed to be a nativity scene that is a puzzle.
Sent from my Xoom using Tapatalk 2
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.