cut out and tabs

[aokweld101]

i did use the pierce tool and the sellect all...:?

[lawrence]

don't select all- just select the lines (not the pattern) - this will make the "place tabs" button available to press

Lawrence

[fwharris]

i did use the pierce tool and the sellect all...:?

Aubrey,

Is this for your shelf bracket?? If so was there a special reason why you are trying to carve this instead of just doing the cut out paths??

[fwharris]

Just an update for all who were trying to help out Aubrey. He contacted for setting up a DXF file for a shelf bracket and we got that worked through. I've shown him a faster way instead of trying to carve (raster) the bracket and then cut it out. Just applied the cut path to each vector line so he could cut it out.