Where's copy offset?

[bluecobra]

I'm attempting to create a cut out of Jerry's license plate (http://forum.carvewright.com/showthread.php?21179-I-m-a-Big-Hit-With-The-Ladies.....). I've read in a few places about copy offset. Is this found in Designer or is it in one of the software packages? It would be a lot easier to copy offset the border of the plate and apply a cut path to it.

[cnsranch]

Mark - FWIW, I trim the plates on the table saw, trim the corners 45 degrees with a miter saw, and sand them round.

Can't be of any help with copy offset, sorry.

[SteveNelson46]

bluecobra

The copy offset tool is part of the 2D Advanced Vector Drawing Suite. If you have purchased this add-on it should be under the "Tools" menu

[bluecobra]

Jerry, thanks for the info. I have limited sanding capabilities hence the cut out route. I suppose if I made enough of them I could make a router template and cut them out that way too.

Thanks Steve. I remember reading about it, just couldn't remember where it was located or what software package it was in.