sail
10-09-2012, 02:56 PM
I have posted several problems with all three axis ( axies? ) I was offered MANY probable solutions. It was easier than that .
There was no problem with the sand paper belts, no wear on the MDF jig etc. ALL were welcome and valuable suggestions. Thank you ALL for the suggestions.
The problem seems to have started when I downloaded an update to the firmware. If you do this, you MUST confirm that the flash card, or portable memory card has been updated as well.
Plug the card and reader into your computer. Open Flash manager. Click firmware and update. My problem was solved. I am carving again.
Sometimes it's automatic. In my case it was not.
Sooo many things to pay attention to and sooo little brain capacity.... Good thing support is available in the forum and at Carve Wright.
There was no problem with the sand paper belts, no wear on the MDF jig etc. ALL were welcome and valuable suggestions. Thank you ALL for the suggestions.
The problem seems to have started when I downloaded an update to the firmware. If you do this, you MUST confirm that the flash card, or portable memory card has been updated as well.
Plug the card and reader into your computer. Open Flash manager. Click firmware and update. My problem was solved. I am carving again.
Sometimes it's automatic. In my case it was not.
Sooo many things to pay attention to and sooo little brain capacity.... Good thing support is available in the forum and at Carve Wright.