2007 Craftsman Compucarve Machine for sale.

[eharsin21]

I am selling my machine for parts. I have over $600 in recent new parts: Less than 20 hrs on new parts.
Z Motor Bundle $100 May 2011
Z Truck $159 May 2011
Power Supply $165 July 2011
Z Truck $159 August 2011
Mother Board $220 August 2011 (can't find receipt)

I rarely used the machine (366 hrs.) and when I did there was always a problem starting a new project. In August of 2012 I sent it in for repair and it was going to cost me another $280 so I purchased a new machine instead. It would be a great machine for parts or if someone wanted to fix it themselves for a second machine. I have a repair sheet showing what needed fixed:
Z motor, Door switch (I bypassed), 8 rollers, X termination board, FFC cable, cut motor.

Asking $400 You can send me a private message.

(please do not share your personal phone # or email on the forum) lynnfrwd

[henry1]

If you look around a bit much for used parts just my 2 cents

[lawrence]

Just as a PSA (and I mean no offense), that's about twice the price that most non-working machines here on the site-- $300-$400 is pretty much the norm. Perhaps you would have better luck on craigslist?

Lawrence

[easybuilt]

A suggestion, maybe just sell the individual parts on Ebay, I saw someone doing it recently and they see to do quite well and you might get close to your price.

[Ike]

Better yet keep it for a parts machine for yourself!

Ike

[eharsin21]

I edited my posting. I was asking $700 due to advise from CompuCarve techs. I have relisted with an asking price of $400. The machine is still packaged from Compucarve repair shop and is ready for shipping.

[eastcutty]

Still have it? What revision?