View Full Version : Manually calibrate for rubber belts...?
jweat002
10-03-2012, 04:23 AM
Ok, Carvers. The last set of rubber belts I installed, I had to "ADD" for the x axis, now my problem is that I am using a 36" (on the mark) board and the machine is reading 36 1/2". For the life of me, I have played around with every button on the control modual and CANNOT figure out how to subtract that half of an inch. Can anyone help me, please?;)
liquidguitars
10-03-2012, 10:14 AM
First thing to check is to make sure that the o ring on the brass roller is not hitting the new belts! it hard to see. so take some time to be sure...
mtylerfl
10-03-2012, 12:18 PM
First thing to check is to make sure that the o ring on the brass roller is not hitting the new belts! it hard to see. so take some time to be sure...
...or, just remove the rubber O-ring...see if that helps.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.