crank handle

[dedgeobo]

any one know how the crank gear is replaced

[chief2007]

Look at this link to this manual, it should help

http://www.carvewright.com/2010CWweb/service/Service_instructions/CarveWright_service_adjust_head_pressure.pdf

[Old Salt]

Ck before replacing that ,you may have to much lube on the washer.

[Digitalwoodshop]

Before you replace the handle gear a cleaning and inspection of the whole gear train should be done. The Head must be checked for level as a un level head will bind... The Jacking Screws will fill with sawdust as will the head threads. A Cleaning with penetrating oil is a cure for dirty threads and the inner surfaces of the smooth rail bearings. Also look at the 2 90 degree gears at the bottom of the machine, you may find the gear area full of sawdust...


And last, the handle has a slot that it slides into as you tighten the screw once it bumps up to the shaft you turn the handle until it falls into the slot and continue to tighten...


Hope that helps... A little more detail would have helped with a more useful reply post.

AL

[dedgeobo]

The link shows how to remove the handle not the gear In The Machine it looks as it may be pop riveted
Look at this link to this manual, it should help

http://www.carvewright.com/2010CWweb/service/Service_instructions/CarveWright_service_adjust_head_pressure.pdfThe