Unable to copy

[cadum2]

:( Been using CW for about 1 1/2 yrs with out to many problems. Was away from the machine for about 1 mo.
started a new dwg. and found I could not copy the image. I don't think I forgot how EDIT COPY, EDIT PASTE
but no knew image shows up. Went to an old dwg. and tried there with the same results. Rebooted the computer same thing. What happened and more important how do I fix it.

Cadum2

[ladjr]

What program are you using . If it is Disign editor I don't think it uses that file type. I usually bring it into Coral or other graphic program and the save as DXF or JPG.

[TerryT]

With the new version the pasted image goes over the original (copied) image instead of being off set. It is probably there and you just didn't know it. After pasting try to move the highlighted image. You should still see the original under it.

[lynnfrwd]

Open the carve list and see there.


Sent from my iPhone using Tapatalk

[cadum2]

thank you that was exactly the problem, it was there all the tiime.
Thanks again

Cadum2