lynnfrwd
08-13-2012, 11:57 AM
Added exciting new tool for Pattern Modeling Suite!
REMEMBER: IF YOU ARE UPDATING FROM 1.182 OR EARLIER VERSION, YOU MUST FOLLOW SPECIAL INSTALLATION INSTRUCTIONS!!
Here is the link: http://www.carvewright.com/downloads/Software_Installation_Windows_post_1-182.pdf
If you already did this and are updating from 1.183 or 1.184, you should be able to just update without removing old version.
If you are running Windows 7 or Vista........always select "Run As Administrator" to install, license or update.
Here is what new in 1.185:
13 August 2012 -- Differences between versions 1.185 and 1.184 * Added "Sweep with rails" to features available with Advanced 3d license. * Fixed an incorrectly reported licensing requirement for "make Pattern" when group contains vector carvings. * Fixed firmware velocity calculation that cause some vectors to carve very slowly. * Installer once again places a shortcut on the desktop. * Fix near vertical/horizontal cut-thru paths that didn't cut. i.e. a vertical line accross board with a cut-thru applied. * Fix loading of mirrored arcs saved prior to version 1.183. * Fix cut path artifact at start / end point of path. * Added reporting of duplicate vertices on board load. * Added levelingTool in Pattern Editor. * Added delete button in flash dialog when in "file upload" mode. * Changed message about "depth reduced" on load to a simple warning that the carving is too deep to cut. * Fixed depth/rise calculation for Patterns made with "make pattern" tool. * Increased maximum zoom scale. * Some improvements to wording in the RegWizard when used with collections. * Fixed a crash when slicing an STL model. * Allow 0.020 inch cut-thru slop on rasters * Increased maximum raster depth from 0.8 inches to 0.82 inches. * Improved drawing performance, and responsiveness on large boards, up to 20X in some cases.
REMEMBER: IF YOU ARE UPDATING FROM 1.182 OR EARLIER VERSION, YOU MUST FOLLOW SPECIAL INSTALLATION INSTRUCTIONS!!
Here is the link: http://www.carvewright.com/downloads/Software_Installation_Windows_post_1-182.pdf
If you already did this and are updating from 1.183 or 1.184, you should be able to just update without removing old version.
If you are running Windows 7 or Vista........always select "Run As Administrator" to install, license or update.
Here is what new in 1.185:
13 August 2012 -- Differences between versions 1.185 and 1.184 * Added "Sweep with rails" to features available with Advanced 3d license. * Fixed an incorrectly reported licensing requirement for "make Pattern" when group contains vector carvings. * Fixed firmware velocity calculation that cause some vectors to carve very slowly. * Installer once again places a shortcut on the desktop. * Fix near vertical/horizontal cut-thru paths that didn't cut. i.e. a vertical line accross board with a cut-thru applied. * Fix loading of mirrored arcs saved prior to version 1.183. * Fix cut path artifact at start / end point of path. * Added reporting of duplicate vertices on board load. * Added levelingTool in Pattern Editor. * Added delete button in flash dialog when in "file upload" mode. * Changed message about "depth reduced" on load to a simple warning that the carving is too deep to cut. * Fixed depth/rise calculation for Patterns made with "make pattern" tool. * Increased maximum zoom scale. * Some improvements to wording in the RegWizard when used with collections. * Fixed a crash when slicing an STL model. * Allow 0.020 inch cut-thru slop on rasters * Increased maximum raster depth from 0.8 inches to 0.82 inches. * Improved drawing performance, and responsiveness on large boards, up to 20X in some cases.