Metric Reading on Keypad

[AllThingsWood]

After changing out the board sensor and getting ready to run another project, me boards are all measured and shown in metric measurements. How do I change my machine back to standard inch measurements?

[AskBud]

After changing out the board sensor and getting ready to run another project, me boards are all measured and shown in metric measurements. How do I change my machine back to standard inch measurements?
Begin by pushing the Option button (ZERO). From there arrow to User Options (5) and press ENTER, and then arrow to the Measurement screen. Pushing the ENTER changes it from METRIC to STD. Once the correct message is showing, press STOP and exit the options.
This should put you back to normal. If not, repeat the process more deliberately.
AskBud

[AllThingsWood]

Thanks
This is exactly the help thAT i needed. You guys always come thru with the answers to help,