View Full Version : Need help with a pattern layout
jaustin
07-28-2012, 11:16 PM
I made a pattern and need help duplicating it so it will be on the same board twice. end to end with about 1" between each pattern
board length will be 42"
tried duplicating but it gets all out of whack.
Thanks for any help.
John
here is the program file
54998
http://i94.photobucket.com/albums/l89/gunracksonline/rest.jpg
ladjr
07-28-2012, 11:57 PM
I hope this is what you had in mind. The problem was you had mirror function active. Once I remove that I had no problem. Hope this works for you.
jaustin
07-29-2012, 12:08 AM
thanks that is perfect.
How do you turn off the mirror function?
AskBud
07-29-2012, 05:13 AM
thanks that is perfect.
How do you turn off the mirror function?Leo probably deleted the mirror, and used Copy & Paste instead.
Be advised that Leo also has assigned the 3/16 cutting bit!
AskBud
ladjr
07-29-2012, 12:16 PM
To turn off the mirror simply highlight the item and then click on the mirror button
Leo
jaustin
07-29-2012, 02:52 PM
thanks
John
SteveNelson46
07-29-2012, 08:32 PM
John
I did this with the new copy offset tool. I don't know if it's what you are looking for but, I had a lot of fun doing it for the experience!
ladjr
07-29-2012, 08:36 PM
John
I did this with the new copy offset tool. I don't know if it's what you are looking for but, I had a lot of fun doing it for the experience!
Steve
That is exactly what I did below
SteveNelson46
07-29-2012, 08:47 PM
Leo
I didn't look at your post before posting mine. I guess I just re-invented the wheel.
ladjr
07-29-2012, 09:04 PM
Leo
I didn't look at your post before posting mine. I guess I just re-invented the wheel.
Don't worry about it. I don't know how many times I have done the same thing
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.