kyeakel
01-28-2007, 12:17 PM
I wonder if the carvewright software is just depth based or does it take the bit geometry into account? Say if we use the carving bit, the letter depth may make the angle of the bit cut away part of the top of the letter. I'd hope the software would make an adjustment to the depth around the letter in order to keep the letter width at the top constant.
Anyone know what's happening? Seems like my letters are a bit thinner at the top than designer shows them to be
Anyone know what's happening? Seems like my letters are a bit thinner at the top than designer shows them to be