View Full Version : can you change carving bit while work in progress?

01-28-2007, 11:26 AM
Will the machine have a problem if i replace carving bit with a new one in the middle of a project?

01-28-2007, 11:33 AM
The machine must have the same bit unless the replacement is exactly the same length.

01-28-2007, 11:52 AM
Thanks for the fast answer, That was what i thought. Did not want to try it until i heard back

01-28-2007, 02:39 PM
That sounds like a good idea for the next firmware upgrade. A Function Code that you can enter via the keypad that lets you change bits mid job and tells the processor to re check the bit depth again before starting.