View Full Version : can you change carving bit while work in progress?
newcarver
01-28-2007, 11:26 AM
Will the machine have a problem if i replace carving bit with a new one in the middle of a project?
pkunk
01-28-2007, 11:33 AM
The machine must have the same bit unless the replacement is exactly the same length.
newcarver
01-28-2007, 11:52 AM
Thanks for the fast answer, That was what i thought. Did not want to try it until i heard back
Digitalwoodshop
01-28-2007, 02:39 PM
That sounds like a good idea for the next firmware upgrade. A Function Code that you can enter via the keypad that lets you change bits mid job and tells the processor to re check the bit depth again before starting.
AL
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.