PDA

View Full Version : Help with z-axis



tmac
07-20-2012, 09:14 PM
This is my first post so if I did something wrong< I apologize. I am Having machine problems. It started with Z-axis stall error code 06-0313.After checking several of the recommended fixes posted here, I now get the error as soon as I try anything. Power on then options then 8. Gives me a remove bit and board and press any key. The result is back to the test. This happens no matter what test i'm trying to run. If board and bit are installed I get error as soon as project is selected. Machine is a C series with just over 100 hours. I have had nothing but problems with this machine since day 1. Getting very frustrated as I can't even get it to drill holes for simple cribbage board. Hate to think what happens if I try a more complex carving. Thank you in advance for any help provided.

Digitalwoodshop
07-20-2012, 09:31 PM
With 100 hours I am betting you have a bad FSC Cable. The flat cable that brings power to the Z Motor and returns Encoder Data.

Look for cuts and if it is pushed in all the way.

WELCOME

AL