View Full Version : lip on an oval using the new tools
myshop1044
07-17-2012, 08:54 PM
attached is my first attempt to do raised lip on an oval.
I did one for a circle very easy, but the oval does not seem to work
using Extrude.
How do I make a lip around the oval with the new tools?
Perry B.
fwharris
07-17-2012, 09:02 PM
Perry,
Use the "sweep rounded" tool Place your arc centered on the white line
myshop1044
07-17-2012, 09:11 PM
You are the man Floyd
AskBud
07-17-2012, 09:20 PM
attached is my first attempt to do raised lip on an oval.
I did one for a circle very easy, but the oval does not seem to work
using Extrude.
How do I make a lip around the oval with the new tools?
Perry B.I applied the Round Sweep Tool to the oval. As you found out the Extrude only applies to horizontal or Vertical.
Notice that I extended the bowl line left of the red line to make sure I did not leave a "mountain in the carve.
My "Download" link, below" has a lesson titled "3D Sweep Tool-Part-1" that shows the concept.
AskBud
54804
ladjr
07-17-2012, 09:26 PM
You are the man Floyd
Oh well I spent all this time creating it so here it is.
AskBud
07-17-2012, 09:38 PM
Oh well I spent all this time creating it so here it is.Your MPC has a "Mountain" in the center, by the way you applied the sweep. You may want to review my prior post on how the avoid that situation.
AskBud
myshop1044
07-17-2012, 09:52 PM
Ok here is my newest try, how do I get rid of the little ring on the outside
of the oval, like the circle and the rect.
AskBud
07-17-2012, 09:56 PM
Ok here is my newest try, how do I get rid of the little ring on the outside
of the oval, like the circle and the rect.Your arc does not touch the green line.
AskBud
ladjr
07-17-2012, 10:08 PM
Thanks I didn't look at the side veiw
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.