View Full Version : spiral tool
lawrence
07-16-2012, 07:17 PM
Anyone know what happened to the spiral tool? I can't find if for some reason... probably operator error on my part
Lawrence
bergerud
07-16-2012, 07:34 PM
Not only is it gone but it is really gone. In old projects with spiral it is also gone. I found an old mpc which had the spiral. Not that the spiral was that useful but it should not do this. I think you found a bug that someone is trying to hide!
fwharris
07-16-2012, 07:40 PM
Yes, just 2 red dots... THE GHOST SPIRAL!! :roll:
liquidguitars
07-16-2012, 08:52 PM
Some of the math was changed, I asked for her return, hopfuly the next build.
lawrence
07-16-2012, 09:04 PM
yup, hopefully it will come back. I actually use it quite a bit for layouts and thought it would be especially cool with some of the new drawing tools (esp with the trim tool)
Lawrence
bergerud
07-16-2012, 09:57 PM
I bet the new drawing tools and the spiral were incompatible. I hope it comes back with some pitch control.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.