View Full Version : Not sure if this is the right Place or not, but....
crash5050
07-02-2012, 03:25 PM
I am attempting something that should be simple. I have created 2 ovals, and then some text in the middle. I want the text to stand proud and pocket out the material around it, and I cannot get it. Attached is my attempt, if there are instructions somewhere I would appreciate the help.
Crash
RMarkey
07-02-2012, 03:31 PM
Change the text to "raster mode" and you should be happy.
AskBud
07-02-2012, 03:33 PM
I am attempting something that should be simple. I have created 2 ovals, and then some text in the middle. I want the text to stand proud and pocket out the material around it, and I cannot get it. Attached is my attempt, if there are instructions somewhere I would appreciate the help.
CrashYou have applied centerline text in error. It is for recessed carving only. I think if you just select the "Raster" text option you will be fine.
AskBud
crash5050
07-02-2012, 03:36 PM
It is true, I am happy v:) Thanks
crash5050
07-02-2012, 03:41 PM
One more odd question, is there way to delete the "waste" from a rendering. For example, I have a cutout on the outside oval, and all I want to show is the stuff inside the cutout?
AskBud
07-02-2012, 03:48 PM
One more odd question, is there way to delete the "waste" from a rendering. For example, I have a cutout on the outside oval, and all I want to show is the stuff inside the cutout?As you apply the Cut-path, you may "Flip" the cut to the outside of the line, and "Hide" the outer portion of the board. Without the "Flip" the inner portion may be hidden.
AskBud
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.