PDA

View Full Version : Question on importing images and scanning sled



Don Phelps
01-27-2007, 02:44 AM
NOTE: I split out the following three posts from the pattern sahring thread, so it soes not get full of non-pattern sharing content. Jeff_Birt, Moderator

I am trying to figure out how to take a .jpg image and make it turn out like the patterns here. I am building a shadow chest for a 30 year NAVY vet and I need some patterns of NAVY MASTER CHIEF ANCHORS.

Azbear
01-27-2007, 07:02 AM
Autobody,
I new to this, machine is on order, but am learning much from the forum. Can you give detaliled specs for the one in your jpg with the molding on it? Kind of wood, dimensions, etc.

Azbear
01-27-2007, 07:05 AM
Autobody,

Opps. I left out the important subject manner.
I new to this, but am learning much from the forum. Can you give detaliled specs for the scanning sled in your jpg with the molding on it? Kind of wood, dimensions, etc.

BobHill
01-27-2007, 09:23 AM
Don,

Is this what you needed? If so, then it can be taken into CorelDraw and made into a carvable design with the right gray scale.

Bob