Jomani
06-12-2012, 11:20 PM
Burned up the flexshaft on my CompuCarve and ordered a new Romaxx WD-1. Not sure if I want to spend another $100 to fix this thing. It has 44 hours on the cutting motor and 3 hours on the scanning probe.
I have both full sets of bits - only used the 90 degree V, the rest are still new (all quick change). Scanning probe, memory card, software, 2 carving bits (used) and 1/8 bit (used twice). Cover switch replaced about a year ago, otherwise all original B model. No tears in belt, no errors - just needs a new flex shaft.
Central Coast of California - pick-up only. Make me an offer...
I have both full sets of bits - only used the 90 degree V, the rest are still new (all quick change). Scanning probe, memory card, software, 2 carving bits (used) and 1/8 bit (used twice). Cover switch replaced about a year ago, otherwise all original B model. No tears in belt, no errors - just needs a new flex shaft.
Central Coast of California - pick-up only. Make me an offer...