View Full Version : Need help with a pattern
jaustin
05-27-2012, 05:57 PM
I am able to make the $" circle and the first lip but everything else in the center i lose.
http://i94.photobucket.com/albums/l89/gunracksonline/pot.png
I will try to upload the pattern I have in a few going to try and lay it out again.
AskBud
05-27-2012, 07:00 PM
Try moving your thinking away from the Carve Regions as your option.
I see this as only using concentric circles using straight bits, probably larger than the 1/8".
I would make the MPC 2-sided, with the 1/16 bit used on the back just to make a "pilot" hole which I can finish on the drill press.
My "Download" link, below, has a lesson titled "Pockets and Conforming Vectors" that covers part of what you need, and point to two Tips & Tricks on the subject as well.
AskBud
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.