PDA

View Full Version : Rotate a design on board?



CLARKSCUSTOMDOORS
05-23-2012, 04:02 PM
I need help on placement of a design on my board.
How do I rotate it to put into the right area of my board.
Thanks! I know this may be crazy question but I am fairly new to this,
Thanks again!

AskBud
05-23-2012, 04:09 PM
I need help on placement of a design on my board.
How do I rotate it to put into the right area of my board.
Thanks! I know this may be crazy question but I am fairly new to this,
Thanks again!It is going to depend upon what needs rotated!
We would be better able to give good advise, if you attached your MPC.
In the meantime, my "Download" link below has 3 lessons where the titles begin with the words "Rotate".
AskBud

chief2007
05-23-2012, 04:40 PM
Click on the pattern, then right click the mouse, go down to rotate and choose which way to rotate your pattern 90 left, 90 right or 180

CLARKSCUSTOMDOORS
05-23-2012, 04:41 PM
Thank you so much for your help. I will check out your downloads and hopefully be able to figure it out.