View Full Version : Replacing sandpaper belt
sundog2001
01-25-2007, 04:42 PM
I received new belts today and was told there was a PDF of the procedure for installing. Can anyone on the forum send me this file?
Thanks. :roll:
bamaman315
01-25-2007, 04:46 PM
try this
http://www.carvewright.com/troubleshooting.html
llamma123
01-25-2007, 04:47 PM
I had the same issue, there does not appear to be anything in the forums. Here is the PDF carvwright support sent me. Installation is a snap but not if you dont have the document!
sundog2001
01-25-2007, 08:33 PM
Both responses are appreciated. This should get me going again for the weekend.
Malfunction
01-25-2007, 11:32 PM
my belt broke too. it was after cw hours so i didn't get a chance to order one today. i did however rig it to work.
these are some pictures of what i did to get me by until my belt arrives.
keep in mind that i didn't use the duct tape. although i think it would work if you super glued around the perimeter of it. for me the fiber glass netted tape worked better.
maybe i just got lucky too lol.
Malfunction
01-26-2007, 10:32 AM
i ordered 2 sets of belts today. they are 9.99 for each set and they said they will be here on tuesday. man i am glad i rigged mine to work or i would be disappointed right now. i called in for a day of vacation too so i could keep the chips flying :D .
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.