staang
04-23-2012, 02:31 PM
I saw a video about changing the default carving bit (1/16") to something else. It said to go to the board settings and select the pattern bit tab. Once there select another bit from the drop down list. I did this and selected the 3/16 bullnose bit and then clicked OK. I then uploaded the project and went to the machine. After measuring the board length it asked for the 1/16" carving bit as usual. Not what I wanted.
Is this procedure wrong or perhaps there is no way to change the 1/16" carving bit to the 3/16" bullnose?
If a wrong procedure, how can I change to the 3/16" bit for project carving?
Thanks in advance.
Is this procedure wrong or perhaps there is no way to change the 1/16" carving bit to the 3/16" bullnose?
If a wrong procedure, how can I change to the 3/16" bit for project carving?
Thanks in advance.