jchad1327
01-24-2007, 10:37 PM
I am trying to crosscut and rip a board 3/4 in thick but it says the board is to thick.
The crosscut and the ripping worked the first time, then I tried to carve a object and it said it was rounding over the edge. I watched it go to the center and it drilled a hole and it kept going until it hit the metal rod in the center. Now it is saying the board is to thick every time.
The crosscut and the ripping worked the first time, then I tried to carve a object and it said it was rounding over the edge. I watched it go to the center and it drilled a hole and it kept going until it hit the metal rod in the center. Now it is saying the board is to thick every time.