PDA

View Full Version : Carve Region



racer
04-03-2012, 09:02 AM
I'm trying to help a Church I sold a new CW to with the front of there Church and need some help with this.
Fa, Paul wonts a edge around this . When I invert the carve region goes away. I need a 1/2" edge and the pattern inverted. Thanks for any help. John

AskBud
04-03-2012, 09:41 AM
I'm trying to help a Church I sold a new CW to with the front of there Church and need some help with this.
Fa, Paul wonts a edge around this . When I invert the carve region goes away. I need a 1/2" edge and the pattern inverted. Thanks for any help. JohnI'm not sure what you are looking for. Could you re-state your design wish. If you invert the pattern the design will be like a jello mold, rather than standing proud as normal. Do you want a edge that is lower than the pattern.
AskBud

lynnfrwd
04-03-2012, 10:24 AM
Rather than stretching the pattern to fill the 7 foot span, you might consider copying and pasting to fill the space. That way the pattern is not skewed.

lynnfrwd
04-03-2012, 10:37 AM
52203

You could assign a cut path (flipped) and also Select a bit (3/8" straight) and inset it.

racer
04-03-2012, 10:44 AM
Thanks for all the help I have talked with the Church and they put this one on hold till I can go up to the Church and talk.
Thanks John

lynnfrwd
04-03-2012, 10:56 AM
5220552204

Here they are inverted and not inverted.

Ok...I see your message now.

chief2007
04-03-2012, 11:53 AM
Think this is how you want it - inverted with an edge,

Hope it helps

Digitalwoodshop
04-03-2012, 03:07 PM
I am doing a Church Project too with Grapes... I made a Carve Region .1 deep and inserted the Grapes with medium draft.... Still working on the design stuff....

AL