PDA

View Full Version : Source for set screws...



Marzluf
01-24-2007, 08:21 PM
I dropped one of my bit adapters on the workbench and it dented the end of the set screw enough that I can't get an allen into it. Does anyone know of a good source for just the set screws (and possibly stronger ones) ?

McMaster Carr Maybe ??

BobHill
01-24-2007, 08:59 PM
I don't have the numbers in front of me, but if you don't have them, check with one of the CW guys for what the size is and then check with someone like http://www.smallparts.com/products/descriptions/ssx.cfm?Source=GG&cpgn=Micro%20Miniature%20Fasteners&grp=Set%20Screws&strg= if you can't find a machine screw jobber or shop near you. Sometimes you can find an old fashioned hardware store (the kind that still has even old sewing machine etc. parts) and take the bent one in to match. OR, have you considered cutting a slot in the end which would fit a small screw driver?

Bob

pkunk
01-24-2007, 09:04 PM
Most good hardware stores carry them. I live in a small town of 1000 and our HW store has quite a stock. Quick repair, file the dent off, the socket should be deep enough for removal & replacement.

ChipMonk
01-24-2007, 10:15 PM
Almost all Ace Hardware stores have small parts like set screws. From your listed location of Reynoldsburg Oh there looks to be an Ace about 10 miles away in Columbus. Here is the info:
Schreiner Ace Hardware
1665 Parsons Ave
Columbus, OH 43207
(614) 444-8963
or
Grandview Ace Hardware
1729 Northwest Blvd
Columbus, OH 43212
(614) 488-4151

You might call them first to save a trip.

Malfunction
01-25-2007, 07:54 AM
if you are in a serious pinch and can't get to the store, match the threads of the set screw up with a small screw lying around the house. you might get lucky.

toymaker
01-28-2007, 06:26 PM
I found them at ACE. The specific size is #8-32 at 3/8" long. They will need the coarse threads. Hope this helps. :lol:

GIZMO1D1
01-29-2007, 07:18 PM
thanks i needed that also.....the allen wrench is weak!,,, had to put in vise to remove//locktight to tight..lol....

can recesed (barrel type be used..or is it part of the locking mec. in the head?

Aaron B
01-29-2007, 07:39 PM
thanks i needed that also.....the allen wrench is weak!,,, had to put in vise to remove//locktight to tight..lol....

can recesed (barrel type be used..or is it part of the locking mec. in the head?

I don't think the set screws have a good depth on them. Seems like the allen wrench doesn't get in there very far.

Jeff_Birt
01-29-2007, 07:42 PM
can recesed (barrel type be used..or is it part of the locking mec. in the head?

No, the screw head is part of the quick release mechinsim.