flemingswoodworks
03-05-2012, 01:05 PM
Hello I put a project into my flash card and when I put it in the machine it said "Unreadable project"
so I went back to my PC and the card was reading fractions instead of the project (13/32).so I formated the card and reinstalled the firmware and loaded the project again.. now it shows the project twice on the card and when i look at the firmware on it ..it says "Installed firmware version BAD"..I tryed it on another computer with the software and have the same trouble ..the reader looks like its functioning correct but not sure if the card or reader could be bad. any ideas
Thanks Will
so I went back to my PC and the card was reading fractions instead of the project (13/32).so I formated the card and reinstalled the firmware and loaded the project again.. now it shows the project twice on the card and when i look at the firmware on it ..it says "Installed firmware version BAD"..I tryed it on another computer with the software and have the same trouble ..the reader looks like its functioning correct but not sure if the card or reader could be bad. any ideas
Thanks Will