lmoutdrs
03-04-2012, 11:22 PM
Ok, I had a tear in my FFC cable. I cut the end off near the motor and may have flipped it over when I plugged it back in. Sears parts backordered the parts for over a month. LHC was two weeks on backorder. That is why I cut the cable to try to get the machine to work until parts arrived. installed new cable and termination board, cleaned the rails, cleaned the wheel on the back of the z motor, checked the bearings and so on. started the system and immediately get the z axis stall after choosing a project. unable to go to options and do a test on the motors. when I choose an option and press enter, it goes back to choose an option. Checked the power supply and getting voltage. How do you check the computer or what other suggestions do you have. None of the boards look or smell burnt.