Scale to width

[papawbummie]

When i get the message"scale to width?" what do i do when i do not want it scaled down. Thanks Bert
( i can't find no}

[edzbaker]

If it ask if you want to scale to width, most likely your ACTUAL board is narrower than the board you had set up in designer. Your only choices are load another (wider) board, or scale to width, making your project fit the narrower board you have actually loaded in the machine. At least I think that is the situation you are describing.

Ed

[mtylerfl]

When i get the message"scale to width?" what do i do when i do not want it scaled down. Thanks Bert
( i can't find no}

Hello,

You may want to read the following Tips & Tricks article for some helpful information and details regarding scaling...

http://www.carvewright.com/downloads/tips/CarveWrightTips&Tricks_Mar09.pdf