minimum board thickness?

[bayea]

can i do a "cut out" of a object if the board thickness is a little over 1/4" ? it is a cut out only. . . .

[lawrence]

I use a sled for these cutouts-- just make sure that when the software asks you, tell it you will use a sled (manual jig)
Lawrence

[bayea]

a sled with a carrier board or can i use just rails?

[Kenm810]

I've used Sleds and Carrier Boards to carve and cut out projests down to 1/4" and 1/8" with no problems

[mtylerfl]

can i do a "cut out" of a object if the board thickness is a little over 1/4" ? it is a cut out only. . . .

Hello,

The following Tips & Tricks shows how this can be done...

http://www.carvewright.com/downloads/tips/CarveWrightTips&Tricks_Sept08.pdf

[bayea]

Michael !! LOL that is exactly what i was looking for !

Thank you, thank you, thank you!!!

n