View Full Version : minimum board thickness?
bayea
02-02-2012, 03:56 PM
can i do a "cut out" of a object if the board thickness is a little over 1/4" ? it is a cut out only. . . .
lawrence
02-02-2012, 04:06 PM
I use a sled for these cutouts-- just make sure that when the software asks you, tell it you will use a sled (manual jig)
Lawrence
bayea
02-02-2012, 04:08 PM
a sled with a carrier board or can i use just rails?
Kenm810
02-02-2012, 04:26 PM
I've used Sleds and Carrier Boards to carve and cut out projests down to 1/4" and 1/8" with no problems
mtylerfl
02-02-2012, 08:53 PM
can i do a "cut out" of a object if the board thickness is a little over 1/4" ? it is a cut out only. . . .
Hello,
The following Tips & Tricks shows how this can be done...
http://www.carvewright.com/downloads/tips/CarveWrightTips&Tricks_Sept08.pdf
bayea
02-02-2012, 09:49 PM
Michael !! LOL that is exactly what i was looking for !
Thank you, thank you, thank you!!!
n
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.