PDA

View Full Version : Help Please



rjp736
01-22-2007, 05:13 PM
Why is it that when I make a sign, the letters do not come out as big as they looked while creating the project with the software. When I made it using the carvewright software the letters used up the whole space on the board but when it's made it turns out smaller......can you please help. Thanks

pkunk
01-22-2007, 05:16 PM
Please post the MPC file when you have a question like this so that we may see what is happening.

Ron Smith
01-23-2007, 06:38 AM
I've had the same thing occur when I've done a couple of signs. This one had large, wide letters in the Designer, but when it carved, they weren't nearly as "substantial" as I would have liked.