View Full Version : What are the defaults (speed (x,y,z), cut depth, leads) of every type of "toolpath"
FelixPQ
01-30-2012, 07:26 AM
Hi all,
is there some info on the defaults designer uses for each type of "toolpaths" it can produce and if possible for each "standard" bit?
Thanks,
Felix
Jeff_Birt
01-30-2012, 07:45 AM
I don't think this information has ever been released. For some operations the feed rate is a bit more complicated, i.e. when doing raster carving the feed rate is related to depth.
RMarkey
01-30-2012, 09:58 AM
Chapter 9 of the Carvewright Manual has detailed info about the bits.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.