Raise pattern

[pvincent]

I am trying to carve a comany name with logo. the logo looks good but the letters are not raised enough. How can I ajust the the height?

[henry1]

I am trying to carve a comany name with logo. the logo looks good but the letters are not raised enough. How can I ajust the the height?
Can you put the pattern on here and we can have a look at it and make the ajustment

[chief2007]

Try this - Click on the pattern and go to the block that says Height - lower it from 100 a little at a time until you get what you are looking for.

You can also try increasing the height of the Text, click the height and go up form 100 a little at a time, but make you have to keep an eye on it, you might get some chipping if it is to high.

As Henry1 requested, if you upload the MPC, we can look at it and make an adjustment to help you out.