briggsy97
01-22-2012, 06:28 PM
As I was making a small carve a piece of the Ztruck fell out on to my board. Here is a picture out of carvwrights manual detailing the problem.
50626
I have sent an e-mail to carvewright CS and am awaiting a reply. I didn't find a detail of the Z truck, so I was wondering if anyone knows what this part is? I am also wondering if anyone has been in their Z truck and replaced this part? I'm guessing that this is an entire truck change, but I'm hopeful that I can just replace the little plastic part. I'm a little disappointed I have only had the machine for about 3 months. Any help would be appreciated. Thanks in advance for any help.
Robert
50626
I have sent an e-mail to carvewright CS and am awaiting a reply. I didn't find a detail of the Z truck, so I was wondering if anyone knows what this part is? I am also wondering if anyone has been in their Z truck and replaced this part? I'm guessing that this is an entire truck change, but I'm hopeful that I can just replace the little plastic part. I'm a little disappointed I have only had the machine for about 3 months. Any help would be appreciated. Thanks in advance for any help.
Robert