PDA

View Full Version : what is "clear board sensr"?



bill4760
01-05-2012, 10:11 PM
How do I fix?

chkorte
01-05-2012, 10:23 PM
EVERY TIME IT HAPPENS TO ME THE WINDOW ON THE BOTTOM OF THE z-TRUCK IS DIRTY.

Kenm810
01-06-2012, 05:16 AM
if you put small mirror on the traction belt under the carving head,
you will get a pretty good look at the lens of the board sencer.
I use a fine painters brush and a little low pressure air to clean
mine after nearly every carving. I've only had to replace mine once
in 4 years due to damage to one of the screws.

mtylerfl
01-06-2012, 07:27 AM
How do I fix?

Hello,

There is quite a lot of information posted here on the forum about troubleshooting the "clear board sensor" message. Using the Search feature, I found several threads that may be helpful (tip...when using search, enclose your search term in quotation marks...for example: "clear board sensor" )

Here is just one thread I found that might be helpful for you:

http://forum.carvewright.com/showthread.php?19660-Board-Sensor&highlight=clear+board+sensor