ramlin
01-21-2007, 08:50 AM
I am still evaluating the machine. I have a design with
routed edges. Does the machine route the edges first
or after the carving is done? Also looking at the instruction
manual, and the Sliding Guide Plate that holds the wood in place,
How high is this plate and does it interfer with the edge routing of
a board? Sending a sample of design with edge routing. I would
expect if using a .75 inch thick board, a 1/2 route would be OK.
But if you use .50 inch thing board, could you still make a 1/2
route? Thanks for any info you could provide.
routed edges. Does the machine route the edges first
or after the carving is done? Also looking at the instruction
manual, and the Sliding Guide Plate that holds the wood in place,
How high is this plate and does it interfer with the edge routing of
a board? Sending a sample of design with edge routing. I would
expect if using a .75 inch thick board, a 1/2 route would be OK.
But if you use .50 inch thing board, could you still make a 1/2
route? Thanks for any info you could provide.