View Full Version : pattern help please
woodchip
11-23-2011, 10:27 AM
I know this has been answered before but I can't seem to find it. Why do I get a few holes in my ptns when I make them? They show up anywhere and look like a dot or a spot that the bit would have to make.
Thanks for any advise
Don
I know this has been answered before but I can't seem to find it. Why do I get a few holes in my ptns when I make them? They show up anywhere and look like a dot or a spot that the bit would have to make.
Thanks for any advise
Don
If you are using the pattern editor or Corel you sometimes get those dots. What I do is enlarge the pattern and look for those dots and erase them. Again if you are using pattern editor load the pattern and enlarge it and find the dots and erase them. Keep in mind where they are before loading the pattern! I always forget too fast, so I guess I said that for me!
Ike
woodchip
11-23-2011, 10:42 AM
Thanks Ike, I made a uaw logo for a friend whos retireing and one of the little guys looked like he got shot.
Don
Thanks Ike, I made a uaw logo for a friend whos retireing and one of the little guys looked like he got shot.
Don
Your welcome! I know it is annoying when it happens! I forget what it is called noise or something? Still a pain, but easy to fix! Hope you find them all! If you need help you can e-mail it to me and I will look at it. Let me know and I will PM my e-mail address.
Ike
DickB
11-23-2011, 11:12 AM
The pattern editor noise filter can effectively find and eliminate those for you.
bergerud
11-23-2011, 11:15 AM
Sometimes you can get rid of the holes by choosing Bit Optimization:Best.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.