Last Supper pattern

[jaustin]

I got this pattern from a member on the board and when my computer crashed I lost it. I do have it on my flash drive but I can not get it off from there.

Does anyone know who or where I can get it from again.

http://i94.photobucket.com/albums/l89/gunracksonline/1303315937.jpg

I was asked to make one for a Christmas gift.

Thanks

[cnsranch]

Search the Pattern Sharing Depot - it's there.

[Kenm810]

Jaustin, this is a copy I have, if it helps

[chkorte]

Here is the same pattern without the fancy edge.

[jaustin]

Thanks for the patterns.
John

[easybuilt]

Here is the one your looking for.

[CarverJerry]

Tom's (easybuilt) got it right. That is the last supper that I put together last year and posted here to share with everyone. Seems like people really like it with this pine cone frame on it, took a little but I finally got the depths set right and have sold a few if these myself.

[jaustin]

thanks that is the one I was looking. I have it backed up and stored online now. So if my computers decide to crash again I shouldn't lose them.

[easybuilt]

You are welcome! Hope you had a wonderful Thanksgiving.

[capstar09]

Could anyone tell me how to open the mpc files for the last supper patterns, have not been able to find anyway to open them.

[PCOutlaw]

It should open in Designer when you click on it.

I have a question about the finished product... I do not see a cut path on the project, is it scroll sawed out after the carve?

[CarverJerry]

pcoutlaw, when I put these 2 patterns together I did not do a cutout for it, I just use my bandsaw which gives a little better cutout in the sharp corners. Only takes about 15 mins to cut it out being careful and using pine. Maybe someone can do the outline and make it cutout.

[cnsranch]

This one has been a real hit - not the traditional Last Supper, but folks really like it.

Pattern's here on the Sharing Depot.

[bjbethke]

Tom's (easybuilt) got it right. That is the last supper that I put together last year and posted here to share with everyone. Seems like people really like it with this pine cone frame on it, took a little but I finally got the depths set right and have sold a few if these myself.

Hi Jerry will this Cutout work for you? BJB

[joaquinceuti]

hola haber si yo puedo agregar algo positivo
aqui van estas imagenes

60798
060799608006080160802

esto es lo que tengo
un saludo de españa

[badbert]

hola haber si yo puedo agregar algo positivo
aqui van estas imagenes

6080060802

esto es lo que tengo
un saludo de españa

¿Puede por favor compartir estos dos?

[joaquinceuti]

hola hay van las tallas
60816

060817
que las disfrute

[badbert]

Gracias, señor!!