SharonB
11-20-2011, 04:21 PM
I'm not having a very good morning today. First: I have all my mpc files stored on a pin-drive and suddenly I can no longer access the files. Click once and it says there are 0 files but checking properties it shows there is something on the pin-drive....Oh well, something to figure out later.
Second: When working on the attached file: When I applied the fonts I could not adjust the length/height useing the control points...as they did not appear. So, figuring that something had gone wrong with the CW program I updated from 1.179 to 1.800. This update did not allow me to access the pin-drive but at least I got my control points back. Almost makes a person want to go back to bed and start all over again.
Last, but not least, my brain has decided it doesn't want to deal with any more problems this morning and I can not figure out how to delete the bottom 1/2 inch or so off this design so it can be assigned a cut path. Please explain...in very simple terms, as my brian is ready to go into a tailspin. ps: The design will be used with rails.
pss: Just tried adding text to another design and I don't have the control point to manipulate the size. What have I checked or unchecked to elimates these points?
Second: When working on the attached file: When I applied the fonts I could not adjust the length/height useing the control points...as they did not appear. So, figuring that something had gone wrong with the CW program I updated from 1.179 to 1.800. This update did not allow me to access the pin-drive but at least I got my control points back. Almost makes a person want to go back to bed and start all over again.
Last, but not least, my brain has decided it doesn't want to deal with any more problems this morning and I can not figure out how to delete the bottom 1/2 inch or so off this design so it can be assigned a cut path. Please explain...in very simple terms, as my brian is ready to go into a tailspin. ps: The design will be used with rails.
pss: Just tried adding text to another design and I don't have the control point to manipulate the size. What have I checked or unchecked to elimates these points?